installed power commander v bike wont start throwing ign coil codes

[D.REX]

i installed the power commander correctly as the directions said

i crank the bike it started for a sec then died

now im getting code 33 and 34 which are igntion coil open or short circuit codes

help cant start bike

[stickshift]

Well it's obviously something to do with the PCV coil connections.

 

Check that all plugs are connected properly (and that all wiring is intact), both at the coils, and the inline coil lead plugs.

 

Inspect each plug to check that all pins are inserted properly, making metal-to-metal contact when connected.

 

Lastly, check that the PCV connectors are plugged into the correct coil, they are specific to the left and right coils.

Installation instructions here if you don't have them: http://www.powercommander.com/downloads/22-065/install/pcv/eng22-065.02.pdf

[D.REX]

yea everything is plugged in and plugged up in the right order im thinking its a bad power commander bc when i unplug the commander and put stock plugs back in it fires right up and i get no codes

[mjh937]

There have been one or two others on the forum who had bad PC units.  Dynojet have been good about replacing them.  Let us know how it goes.