Max Colombié Posted March 24, 2019 Share Posted March 24, 2019 Hi, I'm still a new rider and not the best in mechanics... The reservoir of the coolant is empty and I don't know why... I don't see any leaks so it's a mystery for me. I was wondering if I could buy any coolant and put it in (and how), or if I need to do some kind of flush to empty the old coolant? I will then keep a close eye if the coolant is still disappearing. Thanks, Link to comment Share on other sites More sharing options...
Bigturbomax Posted March 26, 2019 Share Posted March 26, 2019 Its a special mix coolant. If you just want to top it off you could swing by the dealership amd pick up a bottle of yamalube coolant. Link to comment Share on other sites More sharing options...
mossrider Posted March 26, 2019 Share Posted March 26, 2019 Just like your car, the bottle is marked with a fill/full line. The rubber cap just peels off like a sippy cup to give access to the tank. There will be a couple of small rubber hoses that remain attached to the cap (in goes inside, one outside the tank when closed). You shouldnt have to flush anything unless it's more than a few years old. In a pinch distilled water can be added if you if don't have premix. Like Big T said pick up a quart of premix from the dealer. Link to comment Share on other sites More sharing options...
Soranov Posted May 21, 2019 Share Posted May 21, 2019 Just fill it up again with yamaha coolant Link to comment Share on other sites More sharing options...
eiffel6565 Posted June 9, 2019 Share Posted June 9, 2019 my bike always looks low, until i put it upright and make it run for a while, then it reads smack in the middle, best of luck. Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.