R6 master cylinder fitting

[phanomenal07]

My stock brake light switch on the oem master some how broke. Someone local to me had an r6 master. I have the spiegler brake lines in the oe configuration.  Does anyone know if the banjo bolt that come with that will fit and work in the r6 master?

Bonus: the spiegler come with aluminum crush washers right? Need to know so I can order some more washers. 

[mossrider]

Just now, phanomenal07 said:

My stock brake light switch on the oem master some how broke. Someone local to me had an r6 master. I have the spiegler brake lines in the oe configuration.  Does anyone know if the banjo bolt that come with that will fit and work in the r6 master?

Bonus: the spiegler come with aluminum crush washers right? Need to know so I can order some more washers. 

Should take the same banjo and if you're careful you can reuse the crush washers too. Otherwise yes, they normally use aluminum but I've seen plenty with copper too. 

[fzar]

I Have galfer SS lines with copper crush washers, unfortunately the rear is oxidizing and (turning a lighter shade of pale, green) i rode today and it wiped clean with my index finger!!! Doesn't relate to anything really other than crush washers. I'm just happy the forum is up and running again. @Cruizin  

[Spatt]

3 hours ago, mossrider said:

Should take the same banjo and if you're careful you can reuse the crush washers too. Otherwise yes, they normally use aluminum but I've seen plenty with copper too. 

If you must reused the crush washers boil them in water.  Otherwise run to the parts store and buy new ones.  Not worth getting hurt over $2.