FZ07 V4 Risers

[Spatt]

Spent some time the couple of nights reworking the risers to give guys height and adjustment options with their rears sets.  The adjustment was a bit difficult to work out since they differently shaped and make sure the adjustment moves back and not and an angle so you can use bike jacks on the pegs.

First scanned the plates alone to overlay the adjustment slots of the stock units.  In the process learned a couple of things in process like any project.  3D printing a couple to double check the fitment and will be able to toss them on a bike in the morning. 

Since we sold out of the non adjustable risers this was a good time to spend the time and finish the new design to get them out and on a couple bikes in the shops.  I will post some pictures tomorrow when they are done printing.