Brapguy Posted August 2, 2021 Share Posted August 2, 2021 Just letting who ever needs to know i tried flashing my ecu on my MT07. Using ftecu program and was unsuccessful many times kept going thru and getting to a point where i would cycle key then it would give me error message and say flash unsuccessful. I had to on the key cycle part when it asks you to ignition off physically unplug the connector from the ecu and plug back in on ignition cycle on part afterwards was able to write normally and not have to disconnect again. Just letting everyone know if you run into that problem give it a try this was on 2021 MT07. Link to comment Share on other sites More sharing options...
dangerousdan Posted April 20, 2022 Share Posted April 20, 2022 I have tried to reflashed mine and with no luck bike back fires on decell. Link to comment Share on other sites More sharing options...
GoldenMT07 Posted April 24, 2022 Share Posted April 24, 2022 (edited) I sent my ECU out to 2 Wheel Dynoworks and my '21 totally stock bike and it runs so much better. I chose them because I can send the ECU back to get re-flashed at no additional cost as I make upgrades. They we very nice and answered all my newbie questions. Edited April 24, 2022 by GoldenMT07 typo 2 Link to comment Share on other sites More sharing options...
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now