JA50N Posted February 22, 2015 Share Posted February 22, 2015 What are the factory torque specs for the header nuts to the motor? Yosh is freaking lazy and decided to put "torque to factory spec" in their instructions. I've searched on here and wasn't able to find even a how to on exhaust install let alone a torque spec for these bolts. Thanks, Jason Link to comment Share on other sites More sharing options...
Premium Member grahamfz07 Posted February 22, 2015 Premium Member Share Posted February 22, 2015 Service manual says 14 ft-lbf, never seen a torque wrench lower than 20ft-lb though. Unless you have an in-lb torque wrench which would be 168 in-lb I just did it by hand, and left the torque wrench in the toolbox Link to comment Share on other sites More sharing options...
JA50N Posted February 22, 2015 Author Share Posted February 22, 2015 Thanks man! Link to comment Share on other sites More sharing options...
Premium Member grahamfz07 Posted February 22, 2015 Premium Member Share Posted February 22, 2015 No problem, hope you enjoy the new exhaust, Best mod on the bike by far! Link to comment Share on other sites More sharing options...
JA50N Posted February 22, 2015 Author Share Posted February 22, 2015 Service manual says 14 ft-lbf, never seen a torque wrench lower than 20ft-lb though. Unless you have an in-lb torque wrench which would be 168 in-lb I just did it by hand, and left the torque wrench in the toolbox My Craftsman 3/8" drive torque wrench goes down to 5 ft lbs. Link to comment Share on other sites More sharing options...
USMCFieldMP Posted February 22, 2015 Share Posted February 22, 2015 If you need a good install guide, Akrapovic makes really good instructions with theirs, and you can look at them on their website. Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.