cmar143 Posted April 20, 2015 Share Posted April 20, 2015 I just got a projector retrofit kit and went to take the headlight apart this weekend and there are two screws that seem impossible to remove without drilling out the back. The two bottom screws that hold the front trim on the light that are between the smaller light housing are the ones im talking about. If anyone has completely broken down the front headlight assembly can you post how you went about removing those screws. Thanks Link to comment Share on other sites More sharing options...
Premium Member ch3rryghost Posted April 20, 2015 Premium Member Share Posted April 20, 2015 Hey @cmar143, i haven't personally taken the assembly apart, however, I wanted to link you to this thread hoping it'll help? http://fz07.org/thread/2173/hid-projector-xenon-headlight-retrofit Not sure if you've come across it yet. Link to comment Share on other sites More sharing options...
cmar143 Posted April 20, 2015 Author Share Posted April 20, 2015 Thanks I did not see that post. However the front bezel that sits around the glass is attached with 4 screws like I described...I got the 2 top ones out through holes in the back of the light but the bottom 2 need a flexible screwdriver or something very small unless you melt the housing and pull that cover right off of the screws. That is what Im suspecting he did as I can see one of the holes in the picture and it doesnt look clean anymore. Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.