xdr Posted August 22, 2015 Share Posted August 22, 2015 Looking at the service manual, it calls for a t fitting "3-way joints" (2) on the vacuum hose for both TBs. One hose goes to the TB nipple (5&6), other to the sync tool(3&4) and the 3rd(1) Are you supposed to have it goto the opposite TB? I know the left TB has a hose attached already to the intake air pressure sensor, so not sure if you just unhook it and leave it unhooked or t it in. My only assumption is that this is different that a manometer and that is why. Is that true? Link to comment Share on other sites More sharing options...
Guest Ralph Posted August 22, 2015 Share Posted August 22, 2015 That's showing a UK bike yours will likely just have a blank on the right body, so number 4 will just go straight to that after taking the bung off that is on the left get a T and a short bit of tube, pull the tube off the body, put the short bit on and connect the pipe you took off to one side of the T no 3 from the tool goes to the other side of the T you only adjust the right body leave the left and set the right to match. Link to comment Share on other sites More sharing options...
xdr Posted August 22, 2015 Author Share Posted August 22, 2015 Got it! Thats what I was thinking but this image/direction was throwing me off. Now to go make my own tool to get ready for the first service. Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.