nomojies Posted April 9, 2017 Share Posted April 9, 2017 Like the title says I changed my brake and clutch levers and now the brake light doesn't light when I apply the front brake lever or tap on the rear brake pedal. Any thoughts.....? Link to comment Share on other sites More sharing options...
Premium Member i28 Posted April 10, 2017 Premium Member Share Posted April 10, 2017 I'd start by double checking the connections for the rear light (under the pillion seat) and then check the fuse. Also, make sure you don't have the brake light stuck on. (Without the brakes you should only see the two stripes on the sides of the taillight and the middle of the brake light should not be lit) Link to comment Share on other sites More sharing options...
Cruizin Posted April 10, 2017 Share Posted April 10, 2017 Yeah, make sure the wiring connections are good, and then adjust your levers correctly, you may have too much slack and the contacts may not be connecting. Yamaha MT-10 ForumYamaha Tracer 900 Forum Yamaha Ténéré 700 Forum Link to comment Share on other sites More sharing options...
Premium Member DewMan Posted April 10, 2017 Premium Member Share Posted April 10, 2017 Since you say your rear break isn't lighting the bulb either... it could just be an inconvenient bulb blow out? Have you replaced the bulb to verify? Just a thought. good luck resolving the issue. DewMan Just shut up and ride. Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.