Jump to content
The MT-07 Forum

R and g spool sliders spinning


phanomenal07

Recommended Posts

Hi I just installed the r and g spool sliders on my fz07 and I can hand spin the spool on both side is this normal or are the suppose to be tight to the axle? Also the two bits on either side can’t be tighten and more and I can keep turning the wrench almost without resistances. Is this normal or did I screw up somewhere?

Link to comment
Share on other sites

I purposely make my spools able to spin as it reduced both wear in a fall AND bending the bolt.

Go forth and modify my son...go forth and modify...

Link to comment
Share on other sites

Archived

This topic is now archived and is closed to further replies.

×
×
  • Create New...

Important Information

By using this site, you agree to our Terms of Use.